question about c32 brakes

[tommyCclass]

i just bought the c32 (used) front calipers/pads and rotors, and just had a couple of questions about it. WHile looking at the brake pads, I noticed that there is a little wire hanging off of it (i think it's the sensor), but on one side there was no sensor. I have a 01' 320, so would the sensor from my original brake pads work? Also, does anyone have a DIY on how to install this? or much it would cost me to take it to a shop to install. :werd: thnkz..:beard:

[714guy]

the little wire is just the brake sensor and should work with the new pads. they fit into the little slot in the middle of the pad. If your handy you can do it yourself and it'll take a couple hours.

[Mark Cummins]